Zhongtao Jun has never mentioned the topic of beautiful seams on ceramic tiles once. As for how many times, Zhongtao Jun can’t remember. Hey, many people will say that this is very simple! It's easy to understand at a glance. Why bother to use it? Many people even think that they can do it themselves. Why do they need to hire a professional decorator? Is that really the case? Then let’s take a look at the steps of Ceramic tile seaming and what issues need to be paid attention to, gogogo
1. What are the steps for tile seaming?
1. Put the caulking agent into the glue gun
First of all, put the caulking agent into the glue gun, and then slowly and evenly push the material into the seam. Generally, after making a path of about 0.2 meters, use a wooden wedge to block the material nozzle, and then immediately Just use your fingers to smooth out the sealant. However, it should be noted that the overflowing material on both sides of the brick joints should be wiped off with a moist sponge, and it must be removed before the caulking agent is completely solidified.
2. Leave a gap of one millimeter deep
After the above process is completed, a gap of one millimeter deep can be left, but before construction, dust or other magazines in the gap must be cleaned with a brush or rag. Then stick masking paper on both sides of the seam. Generally, the masking paper should be about 0.5mm away from the edge of the seam. Then drive it in along the seam and you're done.
3. Immediately apply the caulking agent evenly with your fingers
Finally, after completing the above steps, if the construction is nearly one meter, you should immediately apply it evenly with your fingers.
In addition, it is important to note that when the caulking agent has not completely solidified, that is, when the construction is about one meter away, you must tear off the textured paper immediately, otherwise a series of troubles will occur!
2. What should you pay attention to when sewing?
1. The conditions for caulking should be met
The reserved width design for ceramic tile seams is: 1.5mm-10mm wide and 2mm-5mm deep. If you have floor heating in your home, the depth of the gap in the construction must ensure that the thickness of the glue layer is not less than 2mm. In addition, owners also need to pay attention to the following: oil-based epoxy resin caulking agents cannot be used on balconies, and reactive epoxy caulking agents cannot be used on expansion joints.
2. Clean the gaps between tiles
Before the joint construction, if the gaps between the tiles are not cleaned, it will cause a series of troubles, such as blistering, discoloration, etc. Therefore, before making beautiful seams, you must clean up the garbage in the gaps as much as possible. If necessary, you can clean it again.How many times should I do it?
The above content is what Zhongtao Jun has shared with you about the Steps in tile seaming and some matters that need to be paid attention to during the process. Finally, this is what Zhongtao Jun thinks. , if you want to save money, you can try to do it yourself and see if the effect is good. If you think the effect is good, there is no need to hire a special master. If you want to make it more beautiful, then it is better. It would be better to ask a professional decorator to do it. After all, the decorator is a professional, and his techniques will be relatively experienced, so there will be no errors. Okay, that’s it for today’s content sharing, Zhongtaojun Just run away first!
